This project aims to re-engineer the Inspection Microscope Opti Spec ME3000 to be an automated PC controlled inspection microscope with image processing software. This document describes the design and implementation of the mechanical development on the inspection microscope along with the image processing software.
Table of Contents
1. Introduction -- 2. System model and development -- 3. Safety precautions -- 4. Application of the device in the real world -- 5. Comparison between the most industry products to this system -- 6. Future development -- 7. Bibliography -- 8. Consultation form -- 9. Appendix.Notes
Bibliography: pages 78-79
Empirical thesis.Awarding Institution
Macquarie UniversityDegree Type
Thesis bachelor honoursDegree
BSc (Hons), Macquarie University, Faculty of Science and Engineering, School of EngineeringDepartment, Centre or School
School of EngineeringYear of Award
2017Principal Supervisor
Stuart JacksonRights
Copyright Greeshma M. Chamarthy 2017.
Copyright disclaimer: http://mq.edu.au/library/copyrightLanguage
EnglishExtent
1 online resource (1 volume (unpaged) colour illustrations)Former Identifiers
mq:70453
http://hdl.handle.net/1959.14/1264044
